Clock registers are bound to Virtual Cables so all streams in each cable are coherent.Unlimited number of Kernel Streaming clients connected to each port.Signal mixing (with saturation) between output port clients.PCM format conversion (sampling rate, bits per sample, number of channels).Volume control features (both attenuation and boost).Channel scattering/gathering mode.Watermark control technique to improve stream stability with unstable applications.Stream buffering technique to partially compensate bad application buffering algorithms.Control Panel application to configure cables and watch their state.Audio Repeater application that transfers from any recording to any playback device.Ĭonfigurable Internal Sample rate: To transport audio signal without conversion it will be possible by setting internal samplerate of the cable in order to fit the same samplerate of audio Pin (only for 44.1, 48, 88.2 and 96 kHz frequency).Īlso analyze the info and set up the configurations of those audio programs. Floating point formats are not supported.Almost no sound latency with maximal interrupt/event frequency.RTAudio support with notification events, clock and position registers. Local (console) session only (does not work via Remote Desktop or Terminal Services).Windows 5.x, 6.x and 10.x platforms (32-bit and 64-bit).Up to 256 virtual cable devices (some systems limit number of MME devices).Almost any of fixed point PCM audio formats. As a last chance, you can try to remove the driver manually: In some cases, after successful over-installation you will be able to successfully uninstall the software.
If the uninstaller fails to properly remove software components from the system, try advanced setup mode that allows you to over-install the software. Virtual Audio Cable 4.12 Full Full Version ((BETTER))
0 kommentar(er)
